1968 Chevelle Exhaust Systems - Gardner Exhaust Systems - 1968 Chevelle Exhaust Sytems by Gardner



	Buick

	Camaro

	Chevelle

	Corvette

	El Camino

	Firebird

	GTO

	Nova

	Oldsmobile

	Mopar

	Hurst SC Rambler

1968 Chevelle / SS Exhaust System Kits
The 1968 Chevelle had two different dual exhaust system when GM outfitted these muscle cars. The small block dual exhaust cars recieved 2 1/2" head pipes and 2" tail pipes GM accomplished this by swaging down the head pipes to 2" The 1968 SS with the big 396 used 2 1/2" head pipes and 2 1/4" tail pipes that ended at the back of the car and pointed down and out.. Our exhaust system kits on all applications come with the correct head pipes with wrinkles and flats and correct tail pipes with wrinkles and double angle cut. The kit will also include corect mufflers logo deleted, correct muffler hangers, clamps, screws, installation instructions, diagrams and sealant. tail pipe hangers are available as well as retainers and strap clamps for reproduction authenticity. Ask about our concours pakgage to bump up to corded rubber zinc plated hangers, ss clamps, ceramic coated flanges, retainers and strap clamps. Or pull out all the stops and have us hand build you button head riveted hangers.

1968 Chevelle SS Left and Right Head Pipes Next To Gardner Reproductions

" 1968 Chevelle SS Tail Pipes Next To Gardner Reproductions

1968 Chevelle SS Owned and Restored by David Povio Equipped With Gardner Exhaust

GM A Body Front Hanger

These hangers are correct for 1964-1972 GM A-Body Exhaust Systems They come standard with any of our GM A Body reproduction exhaus systems. We offer them zinc plated built with corded rubbers to simulate the original bias tire rubbers.

1968 Chevelle Tail Pipe Hanger

The 1968 Chevelle Tail Pipe hangers are another Gardner Exhaust Exclusive Reproduction. This hanger has long been unavailable for the enthusiast who has to have his car the way it came from the factory. It is similar to a GM A body tail hanger however, for some reason it makes use of only one strap. Our hangers are reproduced from the original pictured here and come hand built zinc plated with corded rubbers, button head rivets and attaching hardware.

1964 - 1972 GM A - Body Retainer

These retainers were used on the GM A - Body Muscle cars on the muffler hangers. The attaching screw first went through this reatiner and then through the rubber. The reatainer functioned as a washer to protect the rubber on the hanger. Our retainers have been reproduced from the orginal in the picture and come zinc plated. They are a Gardner EXhaust exclusive reproduction and come standard with our concours show pkg. or can be optioned for with one of our entire systems.

2 1/4 " Strap Clamp

This strap clamp was used on many of the GM - A Body Muscle Cars. It was used to attach the tail pipes to the tail pipe hangers. Our strap clamps have been reproduced from the orginal shown here and come zinc plated with the correct sheet metal screw. They come standard with our concours show pkg. or can be optioned with one of our entire systems.