1969 Chvelle Standard Exhaust System



	Buick

	Camaro

	Chevelle

	Corvette

	El Camino

	Firebird

	GTO

	Nova

	Oldsmobile

	Mopar

	Hurst SC Rambler

The 1969 Chevelle SS Stock system kit featured below comes 14 ga aluminized with the correct 2 1/2" head pipes with correct wrinkle bends and flats, extensions, donuts, correct chevy big block flanges, correct 5-9 oval mufflers, correct 2 1/4" tail pipes, front hangers, clamps, installation instructions, diagrams and sealant. We offer reproduction tips, GM heat riser and ss stud kit to complete the assembly. And for those of you who want to ratchet it up a bit stainless steel clamps, zinc plated hangers, ceramic coated flanges, zinc plated retainers accompany our concours show kit

Ask about our Performance package if you are more concerned about a little more flow than being technically correct.

1969 Chevelle SS Stock Exhaust Kit

1969 Chevelle SS Equipped With Gardner Exhaust

GM A Body Front Hanger

These hangers are correct for 1964-1972 GM A-Body Exhaust Systems They come standard with any of our GM A Body reproduction exhaus systems. We offer them zinc plated built with corded rubbers to simulate the original bias tire rubbers.

1964 - 1972 GM A - Body Retainer

These retainers were used on the GM A - Body Muscle cars on the muffler hangers. The attaching screw first went through this reatiner and then through the rubber. The reatainer functioned as a washer to protect the rubber on the hanger. Our retainers have been reproduced from the orginal in the picture and come zinc plated. They are a Gardner EXhaust exclusive reproduction and come standard with our concours show pkg. or can be optioned for with one of our entire systems.

1969 Chevelle SS Tail Pipe Hangers

These hangers are a Gardner Exhaust Exclusive Reproduction. Original hangers accomplished two things, they not only hung the tail pipe, they clamped down on the chrome extensions as well. Our hangers are reproduced from original hangers come zinc plated, built with corded rubbers and our reproduction button head rivets. These hangers are an option with our standard chevelle systems and come as part of the chambered system package.

1969 - 1972 Chevelle SS Tips

Althogh these tips are not one of our own reproductions they are an excellent copy of the original tip in the picture to the right. From the research we have done original tips on the early 69 Chevelle SS actually had a rolled tips but this was done away with after trapped water caused the tips to rust. Original tips did not have a part number, however, NOS tips do. These reproduction tips do not have any stampings and are as close to factory as possible. They are an option with our 69 -72 SS Chevelle Systems.